![]() Listen for a click and the water heater status light should start blinking ignites.Press the red control button in for a few seconds and while pressing in, button every few seconds.Turn the control switch to pilot light mode.Let the water heater sit for 5 minutes to release gas from the system.Turn the Bradford White water heater off on the control panel.How to Light a Bradford White Water Heater Pilot Light Place the access panel back onto the side of the water heater.Turn the gas control knob to the “ON” position.Hold the red button down for about 60 seconds after the pilot is lit, then slowly let the button back up.You may need to press down on the ignitor button two or three times before the hot water heater pilot light comes back on. While continuing to hold down the red button, press down on the ignitor button until the pilot light comes on.Push down on the red button (this will allow the gas to flow to the burner assembly). Set the gas control knob to the “Pilot Light” position.Turn the gas control knob on the side of the water heater to the “OFF” position and allow the room to air out for approximately 10 minutes.Smith or State water heater and set the panel out of the way. Take the access panel off the side of the A.O.Smith water heaters and State water heaters including the Conservationist model, use a piezoelectric igniter system that allows you to light the pilot by pushing the ignition button Smith or State Water Heater Pilot LightĪ.O. Set the hot water temperature dial to your preferred water temperature.Rotate the gas knob to the “ON” position.Reattach your water heater’s outer door.Continue to hold down the red button for one minute after the pilot light is lit and then release it.You can see the pilot light through the viewing window on the Rheem water heater’s inner door. While continuing to press down on the red button, press the piezo ignitor striker repeatedly until the pilot light is relit. On the left of the gas knob is the piezo ignitor striker.Press down on the red button to the left of the gas knob.Rotate the gas knob counter-clockwise until it is in the “Pilot Light” position.Lift off the outer door of your Rheem water heater.Wait five minutes to let through any gas in the water. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |